Larson, Dimitar, Muntasir and Kasim Bahamas

  • 19756 replies
Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19080 on: August 13, 2019, 09:38:12 pm »
Works for me. I just posted a few test threads in each marketplace forum.

Are you getting a particular error message?

Have you tried a different browser?

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19081 on: August 14, 2019, 12:06:51 am »
One idea that just popped into my head, that I don't recall seeing before, is putting on the bottom of a laptop something similar to what you have on the bottom of keyboards where you can extend plastic tabs to pop up the back of the keyboard.

Put something similar on the bottom of the chassis that is perhaps made of metal or extremely strong plastic to support the weight of the machine. Unlike a keyboard though that just has the two in the back, put four on the bottom of the chassis. One in each corner. If they are "foldable" just like those on the bottom of the keyboard, you could choose to prop the front, back, or the whole thing. Most people always say to prop up the machine if you can for better ventilation/cooling, and the rubber feet on the bottom of the machine typically serves no purpose other than preventing scratches on the surface of where the laptop sits.

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19082 on: August 14, 2019, 06:33:05 am »
Just a minor idea, but bring back physical display latches on big notebooks. My HP 8740w has two heavy duty latches which don't come undone unless I press a button. Display latches are important for bigger notebooks since their displays are heavier, and magnets sometimes aren't strong enough to hold them together with the chassis, especially if you're carrying the notebook at your side with the front of the chassis pointing upward.

Another one: for 17.3-inch and larger notebooks, actually design a keyboard that takes advantage of the width, with full-size numpad keys. 15.6-inch notebooks with numpads almost always have 2/3-sized keys in the numpad so they'll fit, which is understandable, but it annoys me to see those same keyboard put on the 17.3-inch models. That's cost cutting. I want a full-size numpad.


« Reply #19083 on: August 14, 2019, 07:40:57 am »
Я купил этот парсер
и не жалею.Иногда даже акции бывают

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19084 on: August 14, 2019, 12:35:47 pm »
You have to be careful with the tape and CPUs with IHS. If heat melts it, you may end up with IHS basically glued to heatsink. It happened to me when upgrading from 7700K to 8700K, it wouldn't move even a bit, I had to bend heatsink a little to reach socket lever and release it.

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19085 on: August 14, 2019, 03:12:37 pm »
I wanted to gather some information from experienced individuals whove used 33 tape to surround their CPU die and the longevity of it.

Its rated up to 105c and I have machines out in the wild since Haswell with a Zero percent failure rate so far.  Ive even taken some apart as some buyers didnt want LM and everything looked like the day it was applied minus the die etching/staining that occurs. 

Every once in awhile including today I get the viewer who is absolutely positive that this is a terrible method and wants to argue without looking for evidence to support their case.

So this post is for those that want their case supported regardless of what side youre on.

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19086 on: August 14, 2019, 04:11:42 pm »
I want:
X99 laptop with 5960X CPUDelid from the OEM/ResellerThree-way SLI1KW AC adapterInternal liquid cooling for CPU and GPU please, no desk-bound colostomy bag for the GPU a la ASUSNo more plastic laptop bodies... metal, metal and more metal in the chassisSecond, I want AMD to make a comeback and kill the monopoly that NVIDIA and Intel have on the industry.

Third, I want a real, full-fledged, fully functional OS replacement for Microoft Windows. Since they have lost their way and are trying to do a one-size fits all OS loaded with spyware, the Redmond Mafia is no longer adding value to being a PC owner. I want a new OS that can run anything made for Windows; not a half-baked Linux that only does some things well... and not something from Apple. Something fitting for the hardware mentioned under my first want.

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19087 on: August 14, 2019, 04:42:01 pm »
I would like to second these suggestions. All good ideas I think. But I see that the OP is from 2016 and no response so I can only take that to mean nothing is happening to create an app such as that suggested.

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19088 on: August 14, 2019, 04:47:11 pm »
Detatchable screens: easily "pop" off the panel so you can tuck the main chassis somewhere under your desk or by a TV in the living room for when you are not mobile.   

Detachable panel is particularly prudent for using said panel in a multi-monitor setup.   Desk space is prime real estate - it's nice to use a laptop in a multi-monitor setup but if you have a dedicated mouse and keyboard in this arrangement, and why wouldn't you, the bottom base/keyboard of the laptop is big useless block taking up unneeded space on the desk.

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19089 on: August 15, 2019, 01:36:43 am »
An added option to choose real gamer 120/144 hz panels, <2ms no 3d crap like found in BenQ monitors, more mechanical keyboardsMSI idea and a minimum 5 years full company support with new BIOSes as necessary in case new unsupported GPUs arrive in market. Oh and all ideas above this post =D

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19090 on: August 15, 2019, 03:27:51 am »
We started going down that road w/ Stockholm and Moscow.  The problem wasnt w/ Stockhol, it was Moscow.  Really hard to communicate w/ the carriers over there.  Very limited technology.  Are you based in the US?

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19091 on: August 15, 2019, 09:33:28 am »
I used a very tiny amount and rubbed it on the die itself also since there was a little bit stuck on it. You should be okay as long as you clean up all the Brasso / metal polish with rubbing alcohol afterwards.

Also note it did not remove 100 of the "staining" but it did take out all the residue that made the surface rough/uneven causing the higher temps. You should have a smooth finish afterwards.

Slimming World Edlington Hilltop Centre
« Reply #19092 on: August 15, 2019, 12:09:09 pm »
Loss Recommendation, Eating regimen Ideas 'N Tricks
As a substitute of following a fad weight-reduction plan or a over-exercising in an try to shed extra pounds, there is a much healthier solution: Incorporate meals into your food regimen that facilitate a high metabolism, consistent vitality, and extended satiation. Numerous research present that meals and diets with a low energy density make individuals eat fewer energy overall (). That is proven to make you lose as much as 2-3 times as much weight as a typical low-fat, calorie-restricted weight-reduction plan ( 38 , 39 , ). Slimming World focuses on Food Optimising, which consists of three steps: free meals, healthy extras and Syns.\n\nIn the event you're on a low-carb weight loss program , be at liberty to eat fatty meats. Blood sugar tends to go method down on low-carb diets ( 31 ). All of these interventions included dietary modifications, and the added weight-loss profit from activity was small. Research on low-carb diets present which you can even gain a little bit of muscle whereas dropping vital quantities of physique fat ( thirteen ).\n\nHigh in potassium and vitamin C, leeks are present in lots of diet plans to relief extra weight around the stomach brought on by water retention. It is because a low-carb weight loss plan lowers your levels of the fat-storing hormone insulin , allowing your fats deposits to shrink and launch their stored vitality. Individuals often regain weight after the diet and, total, analysis suggests there's little distinction between a VLCD and standard weight loss after 1 to 2 years.\n\nTwo days a week on a restricted food plan can result in greater reductions in body fats, insulin resistance and different  power illnesses. One other frequent mistake when consuming a low-carb eating regimen is getting fooled by the artistic advertising and marketing of particular low-carb merchandise. As mentioned above, meals and diets with a low vitality density are inclined to make folks eat fewer calories.
The perfect canine weight-loss weight loss program is high in protein, low in carbohydrates, and average in fats, which satisfies the appetite. With its food regimen of crimson meat, butter, cream, cheese and mayonnaise, it is one of many diets that appeals most to men. Extra carbs are launched to your food regimen with the intention of understanding what your very best carb intake is to take care of a wholesome weight for all times.\n\nHow long you keep on the eating regimen depends upon how a lot weight it's a must to lose. Greens are very tasty and are indispensable inside our each day weight-reduction plan, these possess a low calorific value while increasing quantity and not contributing to weight achieve. Abstract Salmon is high in both protein and omega-3 fatty acids, making it a sensible choice for a wholesome weight reduction food plan.

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19093 on: August 15, 2019, 12:31:52 pm »
The Blu man comes through again GREAT INFO HERE Wild how many versions there are of that box and so few still around. Like btphoto said, interesting about the International being so different. Hopefully more info will turn up on that one day. Do all of them have light up EQs?

Larson Dimitar Muntasir and Kasim Bahamas
« Reply #19094 on: August 15, 2019, 11:25:51 pm »
Go to walmart and buy a bottle of Brasso and rub off the old liquid metal that turned into the residue on your components and then use rubbing alcohol to wipe the surfaces down. Re-apply liquid metal and try again.

I went through this process with my 8700K and its IHS a couple weeks ago where a re-mount with new liquid metal raised the temps because it wasn't clean. Works great now.